fiestaturbo.com

[mickeyrs]

im helping a pal break his brothers xr2i as he has passed away and it has been left on the drive rotting. I havent any pics as yet but i know its red but the paint is very flat all over. Other than an alarm its totally standard the engine has only done 42k with history. I will get him to get some pics so i can add them any parts you want send me a message located in birmingham











front bumper SOLD
rear bumper SOLD
doors complete with glass no locks or strips SOLD
boot with glass no lock or wiper motor SOLD
bonet SOLD
bottom end £80
cylinder head £50
rad £15
wheels need a refurb and tyres £70













under engine tray SOLD
cenrte part of dash with original radio/casette player £40
centre consol with a few scuffs but most will clean off i think £15
Fuel cut off switch £10
plastic sill trims again a few scuffs £20

not sure on what these are worth so open to offers on all parts listed
will update when ive got pics of other bits

[clouse]

Pm,d

[Buckers1985]

how much for front and back bumper cheers

[mickeyrs]

a few pics of the car all bits available added to first post now

[AndyKam]

I'll have the boot/ tailgate. I'm in walsall. Pm me your address. Could pick up sunday if thats ok.

[jayrs]

looks a shame to brake it mate, is it rotton on the underside?

[focusturbo]

exhaust manifold?

[mickeyrs]

got the manifold and heat shield. Do you want the down pipe aswell?

[RS EDDIE]

Rear interior grey trim (where the ashtray sits) Condition and price please mate.

[mickeyrs]

think its good mate will get some pics tomorrow and send them to you

[RS EDDIE]

Pmd

[jayrs]

the engine undertray is gunna become well sort after soon i reckon, as most people fcuked them off as they were a pain in the ar$e, dont scrap it even if you get no takers on here

[rsturbonutter]

How much you want posted for said engine under tray

[mickeyrs]

rs eddie has first shout on tray pending payment

[RS EDDIE]

Payment Sent geeza.

[mickeyrs]

recived eddie thanks mate

[ginger9860]

Hi buddy how much would you like for the blue exterior door strip - drivers side ?

Thanks

Jim.

[CJC]

Hi -
I need a (non-rusty!) brake servo (but not the master cylinder) - do you have one available?
Best regards
Chris

[mickeyrs]

i will get some pics of it mate so you can see if there is any rust

[mickeyrs]

its covered in rust mate sorry

[CJC]

Thanks for checking

[rsturbonutter]

What is the condition of the driver side rear corner like where the panel meets the arch. Would you be willing to cut this off for me and post it. I have put a picture of the area required in the wanted section. Many thanks Julien

[mickeyrs]

havent got the back bumper off as yet but as soon as i do i will get some pics of the corner for you

[rsturbonutter]

Cheers fella I am hitting the body of mine over the next fortnight and that is the only piece I need now.

[penny07]

Hi

Do you still have the drivers side window regulator?

Thanks

[Pudnpepsi]

is the engine loom avail? cheers!

[mickeyrs]

window reg has gone and the engine loom has been sold

[spam84]

Hi m8, do you have the coolant pipe(s) from the reservoir to the heater matrix and inlet manifold? it should have a y-plastic piece on there too. If so how much posted to manchester?

Thanks,

Sam

[mickeyrs]

i think i should have it i will double check tomorrow when i go round

[RS EDDIE]

Any news with the weights of the tray mate and dimensions????

[mickeyrs]

im going round later to get more bite off so will get it bagged up and weighed for ya

[Rsykes103]

hi i am after a xr2i drivers door ? have you still got this ? thanks Richard

[darren64]

HOW MUCH FOR THE FRONT BUMPER
IS THERE ANY RUST ON THE FITTINGS

[knuckles]

when you remove the blue side mouldings use a fishing line or you will bend them removing them

stick them on ebay as a full set and you should make at least £80 if they straight

[Farooq]

how much for engine loom?