Any good?
4 posts • Page 1 of 1
As the desciption says, "they are new to the market"
If u want a good induction kit, i would rec the piper cross viper.
Takes a direct cold air feed from out side of the car, rather than sucking in hot air.
Im sure u know, cold air is more condensed than hot air.
Thx
If u want a good induction kit, i would rec the piper cross viper.
Takes a direct cold air feed from out side of the car, rather than sucking in hot air.
Im sure u know, cold air is more condensed than hot air.
Thx
- Xr2i_Boy
- Elite Post Master

- Posts: 1444
- Joined: Fri May 09, 2003 9:33 pm
- Location: Bognor Regis Project: Xr2iCE Completion Date: ???? Car Location: DriveWay Targeted BHP: 200
I love PR material, it's always made so you think it's an amazing difference. Looking at some figures on the net, your normal engine would only flow air at about 150 cubic feet per minute (CFM) at the high end of your rev counter (Read: Bouncing off the limiter).
To be looking at gaining a low air resistance at 300cfm, you'd need to be doing somewhere between twice and three times your redline, so about 14-18000 (ish) rpm. In laymans terms...you are never actually gonna see any improvement over a K&N unless you have access to their testing facility.
Now if you have an F1 or Hayabusa bike engine in your fiesta, knock yourself out...but TBH, like everyone has said, the K&N route is probably better/cheaper/more reliable/trustworthy etc.

- Guy Mk4
- Elite Post Master

- Posts: 2880
- Joined: Thu Feb 13, 2003 1:06 pm
- Location: Nottingham Drives: Silver Mk 4 Zetec
4 posts • Page 1 of 1



